LUBE GUIDE
WHAT YOU WILL NEED
Step 1
Take apart your stabilizers, separating into stem, housing, and wire.
Step 2
Lube the inside walls of the housing.
Step 3
Lube the entirety of the sides of the stem.
Step 4
Insert the stem into the housing.
PRO TIP: The side with two holes should be facing the front.
Step 5
Thoroughly lube the wire where it will make contact with the stem and housing.
Step 6
Slip the wire through the stem and clip into the housing.
Step 7
Optional: install stabilizer pads onto your PCB to help with dampening acoustics.
Step 8
Install the stabilizers onto the PCB.
Step 9
Washers can help prevent shorting the PCB but are not required.
Step 10
And you're all done!
And that's it! Enjoy your rattle free keyboard
Video Credits: Karan Chauhan